What should be paid attention to when washing sand gold ore with gold panning machinery?

Gold panning machines are equipment specially used to wash sandy gold mines. The efficiency of manual sandy gold panning is relatively low and the labor intensity is high. Therefore, people have developed a series of gold panning machines to improve the efficiency of washing sandy gold mines. Gold panning machines The use of gold panning machines is very particular. Experienced personnel operate gold panning machines not only with high efficiency, but also with good results. Inexperienced people often have problems of one kind or another when operating gold panning machines. So what should be paid attention to when using gold panning machines to wash sand gold mines? matter?

    In fact, different types of gold panning machines have different precautions during use. For example, in a placer gold ore concentrator using chute gold panning machines, it is necessary to strictly control the cleaning cycle of the chute. Under normal circumstances, the chute needs to be cleaned once every four hours. , but in actual production, due to the difference in the amount of heavy minerals in the placer gold ore, the cycle may be extended, and the cycle is more likely to be shortened. In the placer gold mine with higher iron content, the cleaning cycle of the chute will be longer Shorter, because the iron will quickly fill the gap of the chute, resulting in the loss of gold. In addition, it is necessary to frequently observe whether there is gold running in the tailings of the chute. If there is gold running, the chute must be flushed in time or adjusted. water volume.

    For placer gold ore concentrators using jig machines, the normal operation of jig machines will directly affect the efficiency and effect of placer gold ore washing, so it is necessary to ensure the normal operation of jig machines. The degree of automation of gold panning is much higher than that of the chute, and it does not need frequent cleaning and observation. It is only necessary to take regular samples to observe the content of tailings in the concentrate and whether there is gold in the tailings. If the sand content in the concentrate increases, it is necessary to adjust the jig properly, and if it runs gold, it is necessary to reduce the feed amount.