Irrigation methods for large and medium gold panning boats

Most gold panning equipment uses three different forms of watering. The large-scale special equipment that has is all equipped with automatic watering device, as long as start internal combustion engine, will automatically water.

     Some large and medium-sized gold panning boats are equipped with a combination of water inlet pipe and sprinkler. There is a screw cap on the upper end. Before starting, fill the pump with water and pour water from the screw cap on the water surface. Before starting the internal combustion engine, the screw cap should be tightened, otherwise the water poured in will lose its effect.

     Many small gold panning equipment use a suction hose as a diving device. A screen is installed at the lower end of the hose to prevent gravel and stones from being sucked into the pump, and a one-way valve is also equipped to allow water to enter the pump. hose to prevent water from escaping. The pump installed on the water surface should be pre-filled with water before starting. To make the centrifugal pump pump water, the water level must rise and the pump can only be started after contacting the pump. When water is poured in, when starting, the pump will suck up the water and keep running normally. the

     At present, most of the mobile gasoline internal combustion engines on the market are used to drive the suction gold mining boat. This type of internal combustion engine is the same as the lawn mower and the equipment used in industry. It has the characteristics of light weight and easy movement, and the maintenance rate is also very low. . Some large-scale special-purpose gold-digging ship equipment usually all use the engine of automobile as power.