Welcome to GoldMaster
The characteristics of the gold pan agitating chute: the fixed chute is basically retained, and the original iron bottom plate is changed to a rubber bottom plate, and a simple eccentric agitation mechanism is added to make the rubber bottom plate reciprocate up and down. The diaphragm effect is similar to that of a jig. Thereby solving the hardening phenomenon of the grid and improving the recovery rate of gold. Since the agitation chute discharges ore intermittently, the enrichment ratio is higher than that of the jig.
The structure of the agitation chute: the agitation chute is composed of feed chute, chute part, rubber bottom plate, agitation frame, eccentric agitation system, transmission mechanism, frame and other parts.
Working principle: When the agitation chute is working, the pulp enters the feeding chute, the width of the feeding chute is equal to the width of the chute, slightly lower than the bed surface of the chute, which plays the role of buffering and distributing the pulp, and avoids the direct impact of the pulp on the bed surface. Sorting is carried out after the pulp enters the chute. The sliding grid is made of 40*40 angle steel, with a 50mm wide steel plate on the upper side, and an angle of 0 degrees with the water surface, which can generate a large eddy current when the slurry flows. The upper grid plate is also processed with elliptical holes, which are arranged in a staggered manner. The main function is to make the light minerals in the sedimentary layer under the plate discharged from the holes under the action of agitation. There is an iron stop in front of the elliptical hole to prevent coarse gravel from blocking the elliptical hole. .
The bottom plate of the chute is made of rubber. The agitation of the rubber plate is driven by the motor to drive the reducer and the agitation mechanism, forcing the agitation frame to reciprocate up and down, so that the rubber plate also moves up and down. Through this reciprocating motion, the pulp The light and heavy minerals in the process are layered, and the sediment layer is always kept in a loose state, which is conducive to the recovery of heavy minerals. The slurry goes through a 2800mm long sorting process, heavy minerals and gold particles are deposited at the bottom of the compartment, and light minerals are continuously discharged from the tail. Due to the design of the agitation mechanism on the chute, the chute has been kept in a good sorting state during the long-term sorting process.
Agitation chute alluvial gold extraction equipment: It uses the principle of fixed chute gold selection, and installs a set of silica gel plate agitation device, and mechanically agitates the bottom plate to make the bottom plate agitate periodically to prevent sediment compaction, periodic agitation, and complete stratification and sand discharge , Improve the recovery rate of alluvial gold. The agitating chute has a good effect on capillary gold and thin-skinned gold, and is simple in structure, reliable in operation, less in failure, low in energy consumption, and low in water consumption. It is a practical alluvial gold equipment